ABB COMMANDER C355 - Page 90

88
OPEr
LEVb
b.00
NO
r.d15
NO
b.d15
b.05
b.06
YES
S.AdJ
b.04
YES
FPAK
b.03
Lr
FPLr
b.02
YES
FP.AM
b.01
•1
•1
•1
•1
•2
•1
•2
5.7 Level B – Operator Configuration
…5 CONFIGURATION MODE
•1 Not displayed if the Indicator template in use.
•2 Displayed only if a template with remote set point or cascade control is selected.
•3 Cascade templates only.
b.00...b.06
yalpsiDnoitcAyeKetomeR/lacoL
ON
.elbasidyeketomeR/lacoL
.sedomtnioptesetomerdnalacolneewtebsehctiwS
.2ro1tniopteslacolstceleS
.3ro2,1tniopteslacolstceleS
.4ro3,2,1tniopteslacolstceleS
rL
L2
L3
L4
cL.rL
edacsacdnalacolneewtebgnihctiwshtiwtub,evobasA
deyalpsiderasretemarapevalsnehw
3•
cL.L2
3•
cL.L3
3•
cL.L4
3•
Level B – Operator Configuration
Note. To select this frame from anywhere in this page, press and
hold the
key for a few seconds.
Front Panel Auto/Manual Key Enable
YES – Enabled
NO – Disabled
Front Panel Local/Remote Key Enable
Front Panel Alarm Acknowledge Key Enable
YES – Enabled
NO – Disabled
Operator Level Set Point Adjustment Enable
YES – Enabled
NO – Disabled
Note. Applies to master and slave set points in cascade mode.
Operator Ratio Display
YES – Ratio setting for Remote and Cascade set point displayed in
operator level.
NO – Ratio setting for Remote and Cascade set point not displayed
in operator level.
Operator Bias Display
YES – Bias setting for Remote and Cascade set point displayed in
operator level.
NO – Bias setting for Remote and Cascade set point not displayed in
operator level.
Continued…