19
t. 3.9
SOAK
9.30
•1
X.NN
Current Segment Number
Current Program Number
•2
•3
…2.4 Analog Backup (Templates 5 and 6)
Profile Status
SOAK – Soak segment running
rAMP – Ramp segment running
StOP – Stopped
ENd – End
O.HLd – Operator hold
M.HLd – Manual hold
H.HLd – Holdback hold
r.HLd – Retort hold
r.rMP – Retort ramp
Time Remaining in Segment
[0.0 to 99.9 hours or minutes]
Allows the total segment time to be increased or
decreased by the Time Adjust Value set in the
Profile Control Level. If the current segment is a
ramp, it will change the ramp rate.
Current Program/Segment
[1.01 to 9.30]
When the program is running or held:
Press to skip forward to the start of the next
segment.
Press to skip backwards to the start of the
current segment.
Return to top of page
•1 Profile Status is displayed only if ramp/soak features are enabled – see Section 5.5, Level 9 – Set
Point Configuration.
•2 Segment time adjustment can be disabled in the Ramp/Soak profile control level – see Section
3.4 frame r.18.
•3 Segment skip can be disabled in the Ramp/Soak profile control level – see Section 3.4
frame r.17.
2 OPERATOR LEVEL…
To Next Page
Loading...
