ABB COMMANDER C355 - Page 96

94
…5 CONFIGURATION MODE
C10...C14
Analog Output 2 (ao2) Assignment Source
Select the source required to activate Analog Output 2
See Rear Fold-out/ Table D – Analog Sources.
Analog Output 2 (ao2) Electrical High
The maximum current output required for the retransmission range.
[0.0 to 20.0mA]
Analog Output 2 (ao2) Electrical Low
The minimum current output required for the retransmission range.
[0.0 to 20.0mA]
Retransmission 2 Engineering High
The engineering range value at which maximum output is required.
[In engineering units]
Retransmission 2 Engineering Low
The engineering range value at which minimum output is required.
[In engineering units]
Continued…
0.0
r2L
C.14
NONE
AN2.A
C.10
20.0
AN2H
C.11
4.0
AN2.L
C.12
100.0
r2H
C.13
rLY1
NONE
•1
•1
•1
•1
•1
•2
•2
dG1.P
0.0
r1L
0.0
5.8.3 Analog Output 2
•1 If the output is assigned to a control output by the control type, the setting displayed cannot be changed – see
Section 5.2, Basic Configuration/ Control Output Type.
•2 Not applicable if analog output 2 is assigned to a control output.