96
…5.8.4 Relay Outputs 1 to 4
…5 CONFIGURATION MODE
C23...C24
NONE
rL4.A
C..23
POS
rL4.P
C.24
•1
•2
•3
LEVC
ASSN
•4
•4
•1 If the output is assigned to a control output by the control type, the setting displayed cannot be changed – see
Section 5.2, Basic Configuration/ Control Output Type.
•2 Not displayed if relay is assigned to a control output signal.
•3 Not applicable if relay is assigned to a control output.
•4 Displayed only if relay ouput is fitted.
Relay 4 Assignment Source
Select the source required to activate relay output 4
See Rear Fold-out/ Table C – Digital Sources.
Relay 4 Polarity
The relay can be set to energize for either an active or inactive digital
signal.
POS – Relay energized when source is active.
NEG – Relay energized when source is inactive.
Return to top of page.
To Next Page
Loading...
