ABB DCS 400 - Page 100

II K 4-76
Overview of Software
ParNo. Parameter name and significance Min Max Default Unit
(1)
custom.
setting
Grp 9 Macro Adaptation (continued)
9.19 Disable Bridge1
Bridge 1 will be controlled from binary signal which is
assigned in this parameter.
Assignment identical with 9.05
State of binary signal:
0= Enable Bridge 1
1= Disable Bridge 1. Set affected Torque Ref to zero.
0 10 0 Text x
9.20 Disable Bridge2
Bridge 2 will be controlled from binary signal which is
assigned in this parameter.
Assignment identical with 9.05
State of binary signal:
0= Enable Bridge 2
1= Disable Bridge 2. Set affected Torque Ref to zero.
0 10 0 Text x
(1) no changes possible if the drive is in ON-status