ABB DCS 400 - Page 99

II K 4-75
Overview of Software
ParNo. Parameter name and significance Min Max Default Unit
(1)
custom.
setting
Grp 9 Macro Adaptation (continued)
9.14 AlternativParam
Alternative parameter set will be controlled from a
binary signal which is assigned in this parameter.
Assignment identical with 9.05
State of binary signal:
0= Standard parameter set for speed controller effective
5.07 Speed Reg KP
5.08 Speed Reg TI
5.09 Accel Ramp
5.10 Decel Ramp
1= IF Alt Par Sel (5.21) = Macro depend
THEN
alternativ parameter set for speed controller
effective
5.22 Alt Speed KP
5.23 Alt Speed TI
5.24 Alt Accel Ramp
5.25 Alt Decel Ramp
ELSE
alternativ parameter set for speed controller
effective depending on an event selected in Alt
Par Sel (5.21)
0 10 0 Text x
9.15 Ext Speed Lim
External speed limitation will be controlled from a
binary signal which is assigned in this parameter.
Assignment identical with 9.05
State of binary signal:
0=no speed limitation
1=speed limitation to parameter Fixed Speed 1 (5.13)
0 10 0 Text x
9.16 Add AuxSpRef
Additional aux speed reference will be controlled from
a binary signal which is assigned in this parameter.
Assignment identical with 9.05
State of binary signal:
0=no additional aux. speed reference
1= IF Aux Sp Ref Sel (5.26) = Macro depend
THEN
value of Fixed Speed 2 (5.14) is added to
speed reference.
ELSE
value in Aux Sp Ref Sel (5.26) is added to
speed reference.
0 10 0 Text x
9.17 Curr Lim 2 Inv
Second current limitation will be controlled from a
binary signal which is assigned in this parameter.
Assignment identical with 9.05
State of binary signal:
0=current limitation 2 effective (3.24 Arm Cur Lim 2)
1=current limitation 1 effective (3.04 Arm Cur Max)
Value of Arm Cur Max (3.04) has to be greater
than value of Arm Cur Lim 2 (3.24).
0 10 0 Text x
9.18 Speed/Torque
Speed/torque function will be controlled from a binary
signal which is assigned in this parameter.
Assignment identical with 9.05
State of binary signal:
0= drive is speed controlled
1= IF Cur Contr Mode (3.14) = Macro depend
THEN
drive is torque controlled
ELSE
drive is controlled as selected in Cur Contr
Mode (3.14)
0 10 0 Text x
(
1
)
no chan
g
es possible if the drive is in ON-status