ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
140 2CDC508198D0211 Rev. A | AC/S 1.x.1
7.4.3 Sockets
The data from other ASMs are read into your ASM using input sockets and used in the logic in your ASM.
The results of the logic are output to other ASMs via output sockets.
Create sockets by adding function elements of type SOCKET IN or SOCKET OUT. For each function
element of this type added, the corresponding socket appears with the name set and the data point type.
Overview of the ASM sockets for linking to other modules:
Input sockets
Object name
Data type
Socket IN Configuration-dependent
An input socket appears if you select a Socket IN function element in the configuration. The data point type is dependent on
the function selected.
Signal value:
Configuration-dependent
Output sockets
Object name Data type
Socket OUT
Configuration-dependent
An output socket appears if you select a Socket OUT function element in the configuration. The data point type is dependent
on the function selected.
Signal value: Configuration-dependent
7.4.4 Group objects
No objects available
7.4.5 BACnet objects
No objects available

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English