ABB i-bus KNX AC/S 1.x.1 Series

ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 65
7.2.3.2 Firmware update parameter page
On this page you can update the software in the device. The device configuration is deleted during the
update. Only the physical KNX address and the IP configuration are retained. All values and states saved
are lost. The configuration must be programmed again by means of an ETS download.
7.2.3.3 KNX Programming mode parameter page
On this page you can place the device in the KNX programming mode or deactivate again the KNX
programming mode. See chapter 6.3, Assignment of the physical address.
The current state is displayed and is synchronized with the device Programming LED.