ABB i-bus KNX AC/S 1.x.1 Series - Bacnet Objects

ABB i-bus
®
KNX
Parameters
322 2CDC508198D0211 Rev. A | AC/S 1.x.1
7.10.5 BACnet objects
Type
Object name
Object type
Unit
COV send
condition
Input Heat generator: Supply setpoint temperature External specification Analog value °C (62) -
Output Heat generator: Return temperature Analog value °C (62) 1.0
Output
Heat generator: Supply temperature
Analog value
°C (62)
1.0
Output
Heat generator: Supply setpoint temperature status
Analog value
°C (62)
1.0
Output
Heat generator: Outside temperature
Analog value
°C (62)
1.0
Output
Heat generator: Supply setpoint temperature override status
Binary value
-
-
Output Heat generator: Supply setpoint temperature External specification Analog value °C (62) 1.0
Output Heat generator: Operation mode Positive integer
value
No unit
(95)
1.0
Output
Heat generator: Room setpoint temperature Comfort
Analog value
°C (62)
1.0
Output Heat generator: Room setpoint temperature Standby Analog value °C (62) 1.0
Output Heat generator: Room setpoint temperature Economy Analog value °C (62) 1.0
Output Heat generator: Room setpoint temperature Building Protection Analog value °C (62) 1.0
Output Heat generator: Max. room setpoint temperature Analog value °C (62) 1.0
Output Heat generator: Heat generator On/Off Binary value - -
Output
Heat generator: Room involvement
Analog value
°C (62)
1.0
Output
Heat generator: Control On/Off override disable/enable
Binary value
-
-
Output
Heat generator: Heat generator operating status
Binary value
-
-
Output
Heat generator: Heat generator failure status
Binary value
-
-
Output Heat generator: Room control values Analog value % (98) 1.0
Output Heat generator: Pump override disable/enable Binary value - -
Output Heat generator: Pump override value Binary value - -
Output Heat generator: Pump operating status (Off/On) Binary value - -
Output
Heat generator: Pump relay status
Binary value
-
-
Output
Heat generator: Pump fault
Binary value
-
-
Output
Heat generator: Pump repair switch status
Binary value
-
-