ABB i-bus KNX AC/S 1.x.1 Series - Software;Application

ABB i-bus
®
KNX
Commissioning
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 43
6.4 Software/application
For the AC/S 1.x.1 application controller there is the application "HVAC Application/1.0".
In addition to the ETS application, you will require the ETS Device Configuration App (DCA) "ABB AC/S"
for commissioning; this can be obtained free of charge from the KNX online shop.
For more information on the installation of DCA, see ETS help.
Note
The application "HVAC Application/1.0" and the DCA "ABB AC/S" are supported in ETS 5 only
from version 5.6.5. Earlier versions are not supported.
ETS is required to parametrize the device.
For information on how to use the i-bus
®
Tool, see 4.5 Integration in the i-bus® Tool
Note
A description of the functions is provided in the i-bus
®
Tool online help.