ABB i-bus
®
KNX
Commissioning
52 2CDC508198D0211 Rev. A | AC/S 1.x.1
6.5.8 Copying, cutting and pasting
The device supports different types of copying, cutting and pasting. These functions can be used to copy
similar configurations or example projects.
Copying, cutting and pasting a device
You can copy the entire device including its parameters (ASMs, settings etc.) and the group addresses
linked using the ETS functions Copy, Cut and Paste. Use the advanced Paste function to adjust the group
addresses during the paste.
This works both within an ETS project and between two open ETS projects.
After the paste, the IP address and the BACnet address must be changed because these are only
allowed to be used once.
To Next Page
Loading...
