ABB i-bus KNX AC/S 1.x.1 Series

ABB i-bus
®
KNX
Parameters
66 2CDC508198D0211 Rev. A | AC/S 1.x.1
7.2.3.4 Monitor mode parameter page
On this page you can activate and deactivate monitor access to the ASM automation in the device using
the Status slider. You can see the current states of the logic in the device in real time using the Monitor
function.
For security reasons this access should only be activated if required and then deactivated again.
7.2.3.5 SSH access parameter page
Using this function you can grant the device manufacturer, on request, diagnostic access to the device if
there is a fault.
You can limit the access to a specific number of hours and withdraw it at any time.
See chapter 10.4, Support
.
ATTENTION –
Only activate this function on request from the device manufacturer.