ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
288 2CDC508198D0211 Rev. A | AC/S 1.x.1
This section displays the state of the pump from the heating distribution circuit controller linked. If a double
pump has been activated in the settings, a second section with the label "Pump B" appears. The settings
described here for "Pump A" apply correspondingly to the section for "Pump B".
If activated in the settings, the pump for the heating distribution circuit controller can be overridden by the
"admin" and "expert" users via the web user interface. For this purpose the slider must be dragged to one
of the two "Override" positions.
Status Pump relay
Outputs the status of the pump from the heating distribution circuit controller linked.
Pump operating status
Outputs the operating status (Off/On) provided by the pump. On pumps with their own control, this
operating status can differ from the operating status of the heating distribution circuit controller.
Pump fault
Outputs the fault status provided by the pump.
Repair switch
Outputs the contact position provided by the pump repair switch.

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English