ABB i-bus KNX AC/S 1.x.1 Series

ABB i-bus
®
KNX
Parameters
332 2CDC508198D0211 Rev. A | AC/S 1.x.1
This section displays the state of the pump from the heat generator linked.
If activated in the settings, the pump for the heat generator can be overridden by the "admin" and "expert"
users via the web user interface. For this purpose the slider must be dragged to one of the two "Override"
positions.
Status Pump relay
Outputs the status of the pump from the heat generator linked.
Pump operating status
Outputs the operating status (Off/On) provided by the pump. On pumps with their own control, this
operating status can differ from the operating status of the heat generator.
Pump fault
Outputs the fault status provided by the pump.
Repair switch
Outputs the contact position provided by the pump repair switch.