ABB i-bus KNX AC/S 1.x.1 Series - Page 382

ABB i-bus
®
KNX
Parameters
382 2CDC508198D0211 Rev. A | AC/S 1.x.1
Pump display pump fault status
Options:
No (checkbox cleared)
Yes (checkbox selected)
If the pump outputs its fault status, this status can be received by a group object via this function and
output on the web user interface, in a BACnet object and on the ASM socket. The ASM only displays this
state, there are no switching actions based on the fault status.
Display pump repair switch status
Options:
No (checkbox cleared)
Yes (checkbox selected)
If the pump has a repair switch and the contact position is output, this status can be received by a group
object via this function and output on the web user interface, in a BACnet object and on the ASM socket.