ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 461
Main data point type
Data point type
These two parameters select the data point type for the value recorded. The data point type for the ASM
input socket is set based on this settings and the unit displayed on the web user interface.
The following data point types can be selected:
• 1.xxx [1-bit]
o 1.*
o 1.001 [switch]
o 1.002 [boolean]
o 1.003 [enable]
o 1.004 [rise]
o 1.005 [alarm]
o 1.006 [binary value]
o 1.007 [step]
o 1.008 [up/down]
o 1.009 [open/close]
o 1.010 [start/stop]
o 1.011 [status]
o 1.012 [inversion]
o 1.013 [dimming send type]
o 1.014 [input type]
• 5.xxx [8-bit unsigned]
o 5.*
o 5.001 [percentage (0..100%]
o 5.003 [angle (degrees)]
o 5.004 [percentage (0..255)]
o 5.005 [ratio (0..255)]
o 5.010 [counter pulses (0..255)]
• 6.xxx [8-bit signed]
o 6.*
o 6.001 [percent (-128..127%(]
o 6.002 [counter pulses (-128..127)]

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English