NoteAction
xx2000002452
Check the radial sealing on the swing bottom.
Replace if damaged, as described below.
Note
If the radial sealing requires to be replaced during
the replacement of the base, remove the swing
from the lower arm first. See Replacing the swing
on page 237.
2
Pressfit support of the axis-1 seal-
ing assembly tool, included in
Special toolkit for IP67/Clean
Room/Foundry Plus robots
(3HAC078203-001).
xx2000002453
Place the pressfit support of the axis-1 sealing
assembly tool on the workbench, positioning as
shown in the figure.
3
Continues on next page
230 Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.4.1 Replacing the base
Continued
To Next Page
Loading...
