NoteAction
Big circular plate of the axis-2
sealing assembly tool, included in
Special toolkit for IP67/Clean
Room/Foundry Plus robots
(3HAC078203-001).
xx2000002461
Fit the big circular plate of the axis-2 sealing as-
sembly tool to the swing (opposite side of the ra-
dial sealing) with three M4x12 screws.
3
Grease: 3HAC029132-001Apply a little grease to the sealing lip when repla-
cing the radial sealing and wipe clean after the
replacement.
Note
For Clean Room robots, make sure no grease is
applied to the sealing grooves.
4
xx2000002462
Fit the new sealing into the swing.
For robots with protection type Clean Room
(option 3351-4)
The sealing lip as pointed in the following figure
is facing the inner side of the robot.
For robots with protection type Foundry Plus
(option 3352-10)
The sealing lip as pointed in the following figure
is facing the outer side of the robot.
xx2000002537
5
Continues on next page
612 Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.7.2 Replacing the axis-2 gearbox
Continued
To Next Page
Loading...
