3 Maintenance
3.7.1. Using the SIS system
3HAC023082-001 Revision: E214
© Copyright 2004-2008 ABB. All rights reserved.
3.7 Service Information System, M2000
3.7.1. Using the SIS system
General
This is a brief description of how to use the Service Information System, SIS for M2000 robot
systems. Details may be found in:
• Service Information System, SIS
• Defining the SIS input parameters
• Setting the SIS parameters
• Importing/exporting SIS data
• Reading the SIS output logs
The section is only valid for M2000 systems. For information regarding M2004 robot
systems, see additional documentation, Operating manual - Service Information System:
Art. no. is specified in section References on page 10.
Basic procedure
Action Reference
1. Determine which of the system functions you
require.
These are described in Description of
Service Information System (SIS) on
page 215.
2. Define what values are adequate and
suitable for your application in your
production environment.
Recommendations on how to define
these are given in SIS system parameters
on page 217.
Maintenance intervals recommended by
ABB are specified in section Maintenance
schedule on page 131.
3. Enter these parameters in the system. How to do this is detailed in Setting the
SIS parameters on page 219.
4. Run the robot in normal operation.
5. Reset the counter if a repair is made, or if a
counter for any other reason is restarted.
The TPU displays for resetting any SIS
value are shown in Description of Service
Information System (SIS) on page 215.
6. When a time limit, set in the parameters, is
exceeded, a message may be read on the
Tech Pendant Unit (TPU).
How to access this is detailed in Reading
the SIS output logs on page 221.
7. If the log containing the message is to be
available from an external PC, or if the SIS
parameters are to be entered from an
external PC, a set of software tools are
available to build such an application.
These are described in Exporting the SIS
data on page 222.
To Next Page
Loading...
