3 Maintenance
3.3.8. Inspection, cable harness
3HAC023082-001 Revision: E158
© Copyright 2004-2008 ABB. All rights reserved.
3.3.8. Inspection, cable harness
Location of cable harness, axes 1-6
The robot cable harness, axes 1-6, is located as shown in the figure below.
Note! The cable harness is also available without the division point R2.M5/6. Except for the
connectors at the division point, the rest of the inspection points are the same for the harness
that runs undivided from axis 1 to axis 6.
xx0200000097
Required equipment
A Lower arm
B Cables attached with velcro straps and mounting plate
C Connectors at cable harness division point, R2.M5/6
D Connectors at base
Equipment, etc. Art. no. Note
Standard toolkit 3HAC 15571-1 The contents are defined in section
Standard toolkit on page 436.
Other tools and procedures may
be required. See references to
these procedures in the step-by-
step instructions below.
These procedures include references to
the tools required.
Circuit diagram See chapter Circuit diagram in the
Product manual, reference information.
Continues on next page
To Next Page
Loading...
