4 Repair
4.6.6. Replacement of motor, axis 5, IRB 6600ID and IRB 6650ID
3713HAC023082-001 Revision: E
© Copyright 2004-2008 ABB. All rights reserved.
4.6.6. Replacement of motor, axis 5, IRB 6600ID and IRB 6650ID
Location of motor, axis 5
The motor of axis 5 is located on the bottom side of the wrist, when axis 4 is placed in
calibration position.
xx0500001573
Required equipment
A Motor, axis 5
B Motor connectors, R3.MP5 and R3.FB5
C Wrist side with the axis 5 gearbox
Equipment Spare part no. Art. no. Note
Motor including pinion 3HAC 023745-003 Includes o-ring 3HAB 3772-
22.
Grease 3HAB 3537-1 For lubricating the o-ring.
Power supply - 24 VDC, 1.5A
For releasing the brakes.
Allen key and socket - A specific length is required
for accessing the
attachment screws of the
motor. The dimensions are
shown in the figure Removal
tools, motor attachment
screws on page 372.
Standard toolkit - The contents are defined in
section Standard toolkit on
page 436, in part 2 of the
Product manual.
Other tools and
procedures may be
required. See references
to these procedures in
the step-by-step instruc-
tions below.
These procedures include
references to the tools
required.
Circuit diagram - See chapter Circuit diagram
in the Product manual,
reference information.
Continues on next page
To Next Page
Loading...
