4 Repair
4.6.8. Replacement of motor, axis 6, IRB 6600ID and IRB 6650ID
3813HAC023082-001 Revision: E
© Copyright 2004-2008 ABB. All rights reserved.
Removal, motor axis 6
The procedure below details how to remove the motor, axis 6.
Refitting, motor axis 6
The procedure below details how to refit the motor, axis 6.
Circuit diagram - See chapter Circuit diagram in
the Product manual, reference
information.
Equipment Spare part no. Art. no. Note
Action Note
1. Move axis 4 -90º so that the axis 6 gearbox is facing
downwards. This enables the motor to be replaced
without draining the gearbox oil from axis 6.
2.
DANGER!
Turn off all electric power, hydraulic and pneumatic
pressure supplies to the robot!
For Foundry Prime robots: Do not turn off the air
pressure to motors and SMB.
3. Disconnect the motor connectors. Shown in the figure Location
of motor, axis 6 on page 380.
4. In order to release the brakes, connect the 24 VDC
power supply to the motor.
Connect to connector
R3.MP6:
• + : pin C
• - : pin D
5. Unfasten the motor by unscrewing its three attachment
screws and washers.
Dimensions of the tools are
specified in the figure
Removal tools, motor
attachment screws on page
372.
6. Remove the motor by gently lifting it straight out. Lift
carefully to get the pinion away from the gear.
7. Disconnect the brake release voltage.
Action Note
1.
DANGER!
Turn off all electric power, hydraulic and
pneumatic pressure supplies to the robot!
For Foundry Prime robots: Do not turn off the air
pressure to motors and SMB.
2. Make sure the o-ring on the circumference of
the motor is seated properly. Ligthly lubricate
with grease.
The article numbers are specified in
Required equipment on page 380.
Continued
Continues on next page
To Next Page
Loading...
