2 Installation and commissioning
2.5.7. Orienting and securing the robot
793HAC023082-001 Revision: E
© Copyright 2004-2008 ABB. All rights reserved.
Securing the robot
The procedure below details how to secure the robot to the base plate after fitting the plate to
the foundation.
Hole configuration, base
The illustration below shows the hole configuration used when securing the robot.
xx0600002628
Action Note/Illustration
1. Lift the robot. Detailed in section Lifting robot with
lifting slings on page 68.
2. Move the robot to the vicinity of its installation
location.
3. Fit two guide sleeves to the guide sleeve holes
in the base plate.
Shown in the figure Base plate,
grooves and holes on page 76.
Note that one of the guide sleeve holes
is elongated!
4. Guide the robot gently using two M24 screws
while lowering it into its mounting position.
Make sure the robot base is correctly
fitted onto the guide sleeves!
5. Fit the bolts and washers in the base
attachment holes.
Specified inAttachment screws on
page 78.
Shown in the figure Illustration, robot
fitted to base plate on page 78!
Note! Lightly lubricate the screws
before assembly!
6. Tighten the bolts in a criss-cross pattern to
ensure that the base is not distorted.
Continued
Continues on next page
To Next Page
Loading...
