NoteAction
Specified in Required equipment on
page 229.
Apply locking liquid on the threads of the
lock nuts.
9
Replace if damaged.Fit the support washers on the lock nuts.10
xx1000001262
Refit the lock nuts on the shaft ends. Use a
KM10 socket.
11
Tightening torque: 120 Nm.
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section DANGER
- First test run may cause injury or damage!
on page 45.
12
234 3HAC039838-001 Revision: C
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.4.5 Replacing the linkage - lower link arm
Continued
To Next Page
Loading...
