NoteAction
xx1000001018
Remove the parallel arm.8
If needed, change the bearings.9
Refitting, parallel arm
Use this procedure to refit the parallel arm.
NoteAction
Refitting of the parallel arm is best performed on a
workbench.
1
Specified in Required equipment
on page 259
Apply some grease on the spacing sleeves on the
surfaces that face the parallel arm.
2
xx1000001376
Refit a spacing sleeve on each shaft.3
Continues on next page
262 3HAC039838-001 Revision: C
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.4.9 Replacement of parallel arm
Continued
To Next Page
Loading...
