Emergency stop
The emergency stop function shall not be applied as a substitute for safeguarding
measures and other safety functions but should be designed for use as a
complementary protective measure. (See ISO 13850.)
Note
Emergency stop must not be used for protective stop or program stop as this
causes extra, unnecessary wear on the robot.
For how to perform program stops, see section Stopping programs in Operating
manual - IRC5 with FlexPendant.
Depending on selected options for the robot, the number of emergency stops can
vary. See documentation for the robot and the complete machine.
Other methods to stop the robot
There are also other methods to stop the robot. See:
• Installation and commissioning in Product manual - IRC5
• Technical reference manual - System parameters
• Technical reference manual - RAPID Instructions, Functions and Data types.
20 Product manual - IRC5 Compact
3HAC047138-001 Revision: G
© Copyright 2009-2017 ABB. All rights reserved.
1 Safety
1.2.3 Protective stop and emergency stop
Continued
To Next Page
Loading...
Need help?
General
