1.3.2 Safety symbols on controller labels
Introduction to labels
This section describes safety symbols used on labels (stickers) on the controller.
Symbols are used in combinations on the labels, describing each specific warning.
The descriptions in this section are generic, the labels can contain additional
information such as values.
Note
The safety and health symbols on the labels on the product must be observed.
Additional safety information given by the system builder or integrator must also
be observed.
Types of labels
Both the manipulator and the controller are marked with several safety and
information labels, containing important information about the product. The
information is useful for all personnel handling the robot, for example during
installation, service, or operation.
The information labels can contain information in text (English, German, and
French).
Symbols on safety labels
DescriptionLabel
Electrical shock
xx1400001151
ESD sensitive components inside the controller.
xx1400001162
Disconnect power supply before servicing the controller.
xx1400001161
Disconnect power supply before servicing the controller (only
for welding equipment).
xx1400001160
Disconnect power supply before servicing the controller (for
controllers without UL mains switch).
xx1700000354
Continues on next page
Product manual - IRC5 Compact 29
3HAC047138-001 Revision: G
© Copyright 2009-2017 ABB. All rights reserved.
1 Safety
1.3.2 Safety symbols on controller labels
To Next Page
Loading...
Need help?
General
