ABB Power2 850-M16 - Page 47

Operation Manual / Power2 800-M / 4 Product description
3
Commissioning
Page 15 /
59
© Copyright 2016 ABB. All rights reserved.
HZTL4061_EN
Revision A
September 2016
3.2.2 Checks before commissioning
Filter mat (if available)
 Check for damage and contamination.
Lubricating system
CAUTION
Contaminated oil
Serious damage to engine or property can be caused by dirt and solid mate-
rial particles in the oil.
 At initial commissioning and after all service work, the complete lubricating
system must be thoroughly flushed with warm oil.
 Use special running-in filters when running in the engine and after all ser-
vice work on the lubricating system.
 Check that the oil filter is clean before commissioning.
 Check the oil pressure in the oil supply pipes.
Warning plates
 Check whether warning plates are present and legible.
 Check whether the protective sheets have been removed.
3.2.3 Checks after commissioning (engine in idle mode)
Lubricating system
 Check the oil pressure in the oil supply pipes.
 Check oil inlet temperature.
The admissible values are specified in chapter Monitoring during operation [➙ 17].
Tightness of pipes
 Check all the pipes for tightness.