ABB Power2 850-M16 - Page 56

Operation Manual / Power2 800-M / 4 Product description
5
Operation and service
Page 24 /
59
© Copyright 2016 ABB. All rights reserved.
HZTL4061_EN
Revision A
September 2016
5.3 Expected replacement intervals
 For information on the expected replacement intervals of the components of the low-
pressure stage, see document
Operation Manual / Power2 … / 4.1 Low-pressure stage.
 For information on the expected replacement intervals of the components of the high-
pressure stage, see document
Operation Manual / Power2 … / 4.2 High-pressure stage.
5.4 Stopping the engine
CAUTION
Residual heat in the low-pressure and high-pressure stage
If the residual heat in the low-pressure and high-pressure stage is not suffi-
ciently dissipated by the circulating lubricating oil, machine damage could
occur.
 Observe the post-lubrication times and the oil pressure specified for post-
lubrication (see chapter Monitoring during operation / Lubricating oil pres-
sure).