- 33 -
000827AG
2 - Characteristics
Configurable relays
This functionality is not available yet. It will be implemented soon.
Remote switch-on/switch-off
This command can be used to switch off/switch on the inverter via an
external (remote) command.
This functionality must be enabled in the web user interface and when
active, switching on the inverter, besides being dictated by the presence
of normal parameters which allow the inverter to be connected to the grid,
also depends on the external control for switching on/off.
Reactive power feed into the grid
The inverter is able to produce reactive power and can feed this power
into the grid via the power factor setting.
Power feeding modes vary according to the country of installation and
the grid companies.
Limiting the active power fed into the grid
The inverter can limit the amount of active power fed into the grid by the
inverter to the desired and settable value.
Overvoltage surge arrester monitoring
The inverter monitors the status of the overvoltage surge arresters, and
generates a warning in the event of a fault (viewable via monitoring sy-
stem, internal web user interface or Installer Mobile APP).
Data transmission and control
Embedded multi communication interfaces (WLAN, Ethernet, RS485)
combined with a Sunspec compliant Modbus protocol (RTU/TCP) allow
the inverter to be easily integrated with any third party monitoring and-
control systems that support the same Sunspec standard.
Please contact the ABB technical support or get access to Sunspec alliance website for further
information on Modbus Sunspec products.
To Next Page
Loading...
Need help?
General