- 42 -
000018CG
3 - Safety and accident prevention
Residual risks
Despite the warnings and safety systems, there are still some residual
risks that cannot be eliminated.
These risks are listed in the following table with some suggestions to
prevent them.
Table of residual risks
RISK ANALYSIS AND DESCRIPTION SUGGESTED REMEDY
Noise pollution due to installation in unsuitable environments or where
staff work permanently.
Reassess the environment or the
place of installation.
Suitable local ventilation that does not cause overheating of the
equipment and is sufcient not to create discomfort to people in the
room.
Restore suitable ambient
conditions and air the room.
External weather conditions, such as water seepage, low temperatures,
high humidity, etc.
Maintain ambient conditions
suitable for the system.
Overheating of surfaces at temperature (transformers, accumulators,
coils, etc. ) can cause burns. Also be careful not to block the cooling slits
or systems of the equipment.
Use suitable protective equipment
or wait for the parts to cool down
before switching on the equipment.
Inadequate cleaning: compromises cooling and does not allow the safe-
ty labels to be read.
Clean the equipment, labels and
work environment adequately.
Accumulation of electrostatic energy can generate hazardous dischar-
ges.
Ensure the devices have
discharged their energy before
working on them.
Inadequate training of staff. Ask for a supplementary course.
During installation, temporarily mounting the equipment or its components
may be risky.
Be careful about and disallow
access to the installation area.
Accidental disconnections of the quick-t connectors with the equipment
in operation, or wrong connections, may generate electric arcs
Be careful about and disallow
access to the installation area.
To Next Page
Loading...
Need help?
General