58 Maintenance
To repair the painted surfaces
To repair the painted surfaces, you need:
• Sand paper
• Cleaning towels and liquids (Würth Pro-Clean 0893 140 or equivalent)
• Primer below paint on rusted or deeply scratched surfaces:
Hempadur Mastic 45880 12170 of 280 microns when wet
• Finishing paint: 55210 RAL 7035 of 100 microns when wet.
Refer to the instructions of the primer and paint manufacturers.
If there is damage to the paint surface, but not to the metal surface (no visible rust):
1. Clean the damaged area first with a suitable detergent and then with clean water.
2. Let the surface dry completely and keep it clean.
3. Apply the first layer of paint to the damaged area. Let it dry thoroughly (12 hours).
4. Apply the second layer of paint to the damaged area.
If there is damage that extends to the metal surface or there is visible rust:
1. Carefully remove the rust with sand paper.
2. Clean the damaged area and its surroundings.
3. Coat the damaged area with the primer. Let it dry thoroughly (24 hours).
4. Apply the first layer of paint to the damaged area. Let it dry thoroughly (12 hours).
5. Apply the second layer of paint to the damaged area.
To repair the painted surfaces of the hoods
For any damage to the surface of the hoods damage, examine its extent:
• For damage such as scratches only on the paint surface, use a two-component
polyurethane liquid paint.
• For damage that penetrates the surface coat, apply an epoxy primer paint before the
surface paint.
Refer to To repair the painted surfaces on page 58.
To Next Page
Loading...
