Some parameters, for example the Web HMI mode, cannot be set via
the WHMI.
A070929-ANSI V2 EN
Figure 37: Enable writing to edit a value
The selected setting group is shown in the Setting Group drop-down list. The active
setting group is indicated with an asterisk *.
5. Edit the value.
• The minimum, maximum and step values for a parameter are shown in the
Min., Max. and Step columns.
•
Setting group values are indicated with
.
1MAC054853-MB B Section 4
Using the HMI
615 series ANSI 63
Operation Manual
To Next Page
Loading...
