To Next Page

To Previous Page

49Replacing the RCCB ﬂap

Replacing the RCCB ﬂap

You can replace the side RCCB ﬂap of the power module if it is damaged or otherwise needs to be replaced.

End customer

Specialist electrical

contractor

Construction

Required components:

Number/ spare part 100000256/ Spare part eM4 RCCB ﬂap ABL

Accessories Key for RCCB ﬂap, supplied with the wallbox and the spare part

Tool –

Proceed as follows to replace the RCCB ﬂap on the Wallbox eM4Single:

1 Provided that the RCCB ﬂap is mechanically intact, unlock it

with the key and fold it upwards.

2 Hold the RCCB ﬂap open at an angle of 90° and pull it o

using minimal force.

x The RCCB ﬂap will pop out of the hinge mount in the

housing.

3 Place the two outer hinge pins of the new RCCB ﬂap on the

hinge mounts and press them into the housing using minimal

force.

x The hinge pins will snap into the hinge mounts.

4 Check the replaced RCCB ﬂap to ensure that it moves freely

and then lock it with the key.

Other manuals for ABL Wallbox eM4 Single

Questions and Answers:

Need help?

Do you have a question about the ABL Wallbox eM4 Single and is the answer not in the manual?

General