19Accessories
x Drilling template, 1pc.
x Operating manual & safety information
(multilingual), 1pc.
x Folding ferrite with key, for interference
suppression in the low-frequency range,
1pc.
The Controller variants of the Wallbox eM4Single also include:
x LTE USB stick for installing an optionally
available SIM card for communication
with a backend, 1pc.
x USB filter for interference suppression
of data transmission via the LTE USB
stick, 1pc.
The reev ready variants of the Wallbox eM4Single also include:
x Envelope with reev onboarding guide,
reev RFID test key, reev QR codes, 1pc
x reev charging key (included in enve-
lope), 2pcs.
x Controllers only: LTE USB stick with SIM
card for communication with the reev
backend, 1pc.
x Controllers only: USB filter for inter-
ference suppression of data transmis-
sion via the LTE USB stick, 1pc.
NOTE
Checking the components included
Check immediately after unpacking whether all components are included: should any components be missing, please contact the
dealer from whom you purchased the wallbox.
Accessories
The following accessories for the Wallbox eM4Single are available separately:
x CC3225
Type 2 charging cable according to IEC 62196-2, up to 32A 480VAC, 3-phase,
length2.5m
x CC3250
Type 2 charging cable according to IEC 62196-2, up to 32A 480VAC, 3-phase, length5m
x CC3275
Type 2 charging cable according to IEC 62196-2, up to 32A 480VAC, 3-phase, length
approx.7.5m
x CC3210
Type 2 charging cable according to IEC 62196-2, up to 32A 480VAC, 3-phase, length
approx.10m