51Replacing the charging socket flap
4 Loosen the screw for the locking cylinder with a Torx T15
screwdriver.
5 Push the locking cylinder out of the guide of the RCCB flap
with the screwdriver.
Now proceed in reverse order to install the replacement lock in the RCCB flap.
Replacing the charging socket flap
You can replace the flap of the Type 2 charging socket if it is damaged or no longer closes reliably.
End customer
Specialist electrical
contractor
Construction
Required components:
Number/ spare part 100000261/ Spare part eM4 charging socket flap
Accessories –
Tool Torx TR 20 screwdriver, Torx 20 with hole
Proceed as follows to replace the flap of a charging socket:
1 Open the charging socket flap and locate the four TR 20
screws in the frame of the charging socket flap.
To Next Page
Loading...
