www.accuenergy.com
V: 1.00 Revised: Jan 2021
23
Chapter 6:
Web Interface Readings and Parameter Settings
The AcuRev 2100 supports the HTTPS protocol to allow for the use of a web interface. The user
will need to access the AcuRev 2100 interface to congure the module and use its functions.
The web interface allows for remote initial setup of the AcuRev 2100 meter.
The AcuRev 2100 interface allows for dierent user access levels.
To access the web interface the IP address for the AcuRev 2100 either Ethernet 1, Ethernet 2
or a WiFi IP address must be known.
6.1 User Access Login
Enter the correct IP address of the module in the search bar of the internet browser to access
the web interface of the AcuRev 2100.
The user will be redirected to a web page prompting to select the Access Level and enter the
appropriate password for that level.
The User level is ideal for users who need only to take readings and view status from the meter.
The default password for the User level is view.
It is recommended that no more than 5 users are logged in at the same time for this level to
ensure the optimal performance of the web interface.
The Admin level is ideal for users who need access to congurations on the meter or the web
interface and to view readings.
The default password for the Admin level is admin.
Chapter 6: Web Interface Readings and Parameter Settings
To Next Page
Loading...
Need help?
General
