ACO 3116 - Troubleshooting Guide; Power-Related Issues; Display Malfunctions; General Operation Problems

― 39 ―
A trouble and the processing method
【Power】
Trouble Cause The processing method
This meter does not operate,
even if it pushes a switch.
The battery is exhausted.
E
xchang
e
Batteries.
The polarity of a battery is set
conversely.
Reset Batteries correctly.
It was not long-pressing the
Power button.
Long-pressing the
Power button.
After battery replacement, if the meter does not operate normally,
remove the batteries and insert them again after 5 minutes or more.
【Display】
T
rou
ble
Cause
The processi
ng method
A display value is
The cable is not connected
correctly.
Connect the cable is correctly.
The Accelerometer is not set
correctly.
Set Accelerometer correctly.
【The others】
In addition to this The processing method
Key operation cannot be
performed at all.
①At the time of battery use ⇒ Remove a battery
Slide the battery cover of the back to the lower direction while
pressing down on the cover. Please put a battery after 90 seconds
or more again.
②At the time of AC adapter use
Pull a connector out of the AC adapter terminal of the base.
Please be connected to the AC adapter terminal again after
standing more than 90 seconds.
Data and operation are
T
urned off
a
switch and
long
-
pressing the
power
button
again.