• CAT Interface
Switch CAT interface between RS-232, TTL, BCD, Voltage or OFF;
• CAT Baud rate
Set CAT Baud rate, possible values are between 1200 and 57600 bps;
• CAT Commands
Select one of 5 possible CAT command sets (Set1, Set2, …, Set5);
• CAT Byte spacing
Set CAT Byte spacing between 0 and 1500 ms;
• CAT Polling time
Set CAT Polling time between 200 and 1800 ms or OFF;
• Operate Access
Disable/Enable Operate Access restriction;
• Auto Operate
Disable/Enable Auto Operate feature.
c) Measurements panel
Please, see Figure 5-6 eBox with ACOM 700S connected, Pos. (c).
The panel shows the values of 18 amplifier parameters that indicate power transistors regime, input signal,
temperature, and others.
Panel functional buttons:
• Standby
Set the amplifier mode to Standby;
• Operate
Set the amplifier mode to Operate.
To Next Page
Loading...
