To select the best channel, go to the Device & Channel pane
Select the desired channel from the pull-down
Check Persistent Channel if you want this channel to be used after reboot [recommended]
Return to the Installation tab
Save All Settings To Target and Reboot
Start Service
Re-launch AdaptrumTVBD
In the pop-up, pull down TVBD IP choices, select BASE unit, Connect
If Persistent Channel was checked, the unit will auto-start service (the Start Service button will be gray)
and the Transmit/Link LED (3
rd
-from left) will be illuminated (blue)
Otherwise, if the Persistent Channel was not checked, you need to Start Service
The BASE is now transmitting.
To Next Page
Loading...
