Ferroresonant L-828/L-829 CCR Safety
2009 ADB Airfield Solutions, Incorporated
96A0288T 1-4
All rights reserved Issued 9/04
• Use only electrical wire of sufficient gauge and insulation to handle
the rated current demand. All wiring must meet local codes.
• Route electrical wiring along a protected path. Make sure they will
not be damaged by moving equipment.
• Protect components from damage, wear, and harsh environment
conditions.
• Allow ample room for maintenance, panel accessibility, and cover
removal.
• Protect equipment with safety devices as specified by applicable
safety regulations.
• If safety devices must be removed for installation, install them
immediately after the work is completed and check them for proper
functioning.
Only qualified personnel, physically capable of operating the equipment
and with no impairments in their judgment or reaction times, should
operate this equipment.
Read all system component manuals before operating this equipment. A
thorough understanding of system components and their operation will
help you operate the system safely and efficiently.
• Before starting this equipment, check all safety interlocks, fire-
detection systems, and protective devices such as panels and covers.
Make sure all devices are fully functional. Do not operate the system
if these devices are not working properly. Do not deactivate or bypass
automatic safety interlocks or locked-out electrical disconnects or
pneumatic valves.
• Never operate equipment with a known malfunction.
• Do not attempt to operate or service electrical equipment if standing
water is present.
• Use this equipment only in the environments for which it is rated. Do
not operate this equipment in humid, flammable, or explosive
environments unless it has been rated for safe operation in these
environments.
• Never touch exposed electrical connections on equipment while the
power is ON.
(contd.)
To Next Page
Loading...
Need help?
General