Ferroresonant L-828/L-829 CCR Safety
2009 ADB Airfield Solutions, Incorporated
96A0288T 1-5
All rights reserved Issued 9/04
Do not operate a system that contains malfunctioning components. If a
component malfunctions, turn the system OFF immediately.
• Disconnect and lock out electrical power.
• Allow only qualified personnel to make repairs. Repair or replace the
malfunctioning component according to instructions provided in its
manual.
Allow only qualified personnel to perform maintenance, troubleshooting,
and repair tasks. Only persons who are properly trained and familiar with
ADB Airfield Solutions equipment are permitted to service this equipment.
• Always use safety devices when working on this equipment.
• Follow the recommended maintenance procedures in your equipment
manuals.
• Do not service or adjust any equipment unless another person trained
in first aid and CPR is present.
• Connect all disconnected equipment ground cables and wires after
servicing equipment. Ground all conductive equipment.
• Use only approved ADB Airfield Solutions replacement parts. Using
unapproved parts or making unapproved modifications to equipment
may void agency approvals and create safety hazards.
• Check interlock systems periodically to ensure their effectiveness.
• Do not attempt to service electrical equipment if standing water is
present. Use caution when servicing electrical equipment in a high-
humidity environment.
• Use tools with insulated handles when working with electrical
equipment.
7. Action in the Event of a
System or Component
8. Maintenance and Repair
To Next Page
Loading...
Need help?
General