MotionCreatorPro 111
Circular Interpolation:The setting for circular interpolation mode
has three additional parameters in “Motion Parameters Setting
Frame”. They are arc degree, division axis and optimize option.
Please refer to section 6.7 ,6.8 to set them.
After setting these parameters, you can enter the arc center
and degree in “Play Key Frame”. Click Run button to start cir-
cular interpolation motion.
Jog Type:
Continuous Jog: Continuous Jog means that when you press
one directional button, the axis will continuously move with an
increasing speed. The longer you press, the faster it runs.
When you un-press the button, the axis will stop immediately.
Incremental Jog:Incremental jog means that when you click
one directional button, the axis will step a distance according to
the Step-Size’s setting.
15.Motion status: Displays the returned value of the
_8102_motion_done function. The related function is
_8102_motion_done().
16.Play Key:
Play button: Clicking this button will cause the 8102 start to out-
let pulses according to previous setting.
To Next Page
Loading...
