Chapter 3 Configuring settings
41
OsmoTECH XT Single-Sample Micro-Osmometer User Guide
7. Change these other settings as needed for your lab.
• Mode: Client or Server
• Send Results: See Send-results mode
• LIS Mode: Bidirectional or Unidirectional
8. Press SAVE.
Send-results mode
You can configure the system to send results to the LIS
system using one of these modes:
• Select Automatically to have the system sends results
immediately after each test. If the communication link
becomes disconnected, the results store as LIS
Pending, indicated by a number in the LIS indicator
circle. When the link is restored, the data is sent, and
the indicator number goes to 0.
• Select Manually to have the system accumulate test
results in the results database until a user sends it to
the LIS from the Results screen (see Results).
3.9 Managing instrument data
Administrators and authorized supervisors can export
data from the Results, Events, Users, and Controls
databases:
• To a CSV and/or PDF file
• To a USB drive or to a network folder
• Automatically or manually for data backups
You can also back up data to a USB or network folder,
and export a single result record to a network folder.
NOTE: Supervisor access to SETTINGS > DATA
MANAGEMENT depends on the Change Data
Management checkbox setting on the
SUPERVISOR ACCESS tab (see Assigning user
restrictions).
Press SETTINGS > DATA MANAGEMENT to open the
DATA MANAGEMENT screen.
Configuring data export
Use the EXPORT tab to configure the file format(s) and
location (USB or network folder) used when exporting
the following data:
• Results (see Exporting the results).
• Events (see Viewing and exporting events)
• Users
• Controls (see Displaying and exporting control data)
You can export data to a USB drive or to a network
folder. You can also schedule automatic backups, or
export a single result record to a network folder.
1. Press the EXPORT tab on the DATA MANAGEMENT
screen.
2. Select the Data EXPORT Enabled checkbox.
3. Select the format (PDF and/or CSV) of the exported
data file.
If both formats are selected, then a file in each
format is exported to the configured location (USB
or network folder).
To Next Page
Loading...
Need help?
General
