AEQ BC2000D Series - Page 131

AEQ Audio Over IP
Routing System
131
In the case of NETBOX DSP 128, "Dante Controller" will show the main module with the
previously described channels and 2 additional devices corresponding to the 2 additional
modules with 32 transmission / reception channels per module (named as NBOXDSP_1L,
NBOXDSP_1R, NBOXDSP_2L... NBOXDSP_15R, NBOXDSP_16L and NBOXDSP_16R).
In the case of NETBOX DSP 160, "Dante Controller" will show the main module with the
previously described channels and 3 additional devices corresponding to the 3 additional
modules with 32 transmission / reception channels per module (named as NBOXDSP_1L,
NBOXDSP_1R, NBOXDSP_2L... NBOXDSP_15R, NBOXDSP_16L and NBOXDSP_16R).
The main module could be labelled in "Dante Controller" as NETBOXDSP and the additional
modules as NETBOXDSP-AD1, NETBOXDSP-AD2 and NETBOXDSP-AD3 in order to identify
them (or with any other name that allows to identify them easily on each installation).
NOTE 3: The previous tables show the names of the input/out lines and reception/transmission
channels that are configured by default. These last ones can be edited by means of "Dante
Controller" application, just like the device names, depending on each installation
characteristics.