AEQ Audio Over IP
Routing System
32
4.3.4. Uninstalling "Dante Controller" on Windows.
You should not need to uninstall "Dante Controller" before installing a new version. However, if
you do wish to uninstall "Dante Controller":
Navigate to Control Panel > Programs and Features, select "Dante Controller" and click
Uninstall.
NOTE: Two other Dante features, 'Dante Control and Monitoring' and 'Dante Discovery', may
still be present in the programs list after uninstalling "Dante Controller". Do not uninstall these
features if they are present - they are required by other Dante software applications (for
example, "Dante Virtual Soundcard", Firmware Update Manager, and third-party Dante control
applications). They will be removed automatically if they are no longer required.
4.4. Where to find the "Dante Controller" application?
By default "Dante Controller" will be installed in
C:\Program Files\Audinate\Dante Controller\
It can be started in several ways:
- From the Start menu: Start > Programs > Audinate > Dante Controller > Dante
Controller
- Run by going to Start > Run and entering in the dialog box:
C:\Program Files\Audinate\Dante Controller\DanteController.exe
- Navigate to the directory where it is installed, and double-click the "Dante
Controller" icon.
4.5. Configuring "Dante Controller".
"Dante Controller" can communicate with other Dante devices on the primary network, or the
secondary network, or both. "Dante Controller" needs to know which of the network interfaces of
the host computer is connected to each Dante network. "Dante Controller" supports connection
to Dante networks via Ethernet and Wi-Fi network interfaces.
The first time "Dante Controller" is run,
you may be presented with the Configure
Dante Interfaces dialog box, providing a
list of interfaces from which to select the
primary and secondary Dante interfaces.
Once interfaces have been selected, they
are remembered for future use, and this
dialog box will not be shown when "Dante
Controller" is run subsequently.
NOTE: When connecting a network interface on your computer to a secondary Dante network
with no DHCP server, the network interface should be configured with a static IP address in the
172.31.*.* range, with a subnet mask of 255.255.0.0
The icons displayed indicate the selected interface type and status:
To Next Page
Loading...
Need help?
General
