AEQ BC2000D Series User Manual

AEQ Audio Over IP
Routing System
89
1. In "Dante Controller", open the "Device Config" tab for "Dante Virtual Soundcard".
2. In the "Rename Device" field, enter the new device name and click "Apply".
Locking "Dante Virtual Soundcard":
You can lock and unlock "Dante Virtual Soundcard" from the control panel, or remotely using
"Dante Controller". Refer to section 1.4.7 for information about locking Dante devices remotely.
Changing the Sample Rate:
To change the sample rate for "Dante Virtual Soundcard":
1. In "Dante Controller", open the "Device Config" tab for "Dante Virtual Soundcard".
2. Use the "Sample Rate" drop-down menu to set the required sample rate.
NOTE 1: Changing the sample rate will interrupt audio.
NOTE 2: Increasing the sample rate in "Dante Controller" may reduce the channel count (’Audio
Channels’) setting on "Dante Virtual Soundcard", if the channel count setting is not supported at
the new sample rate. Subsequently decreasing the sample rate, however, will not restore the
channel count setting to its previous value.
Changing the Encoding:
The encoding value is the audio bit depth. To change the encoding setting:
1. In "Dante Controller", open the "Device Config" tab for "Dante Virtual Soundcard".
2. Use the "Encoding" drop-down menu to set the required bit depth.
NOTE: Changing the encoding setting will interrupt audio.
Supported Audio Formats:
The supported audio formats are:
Audio Format Supported values
WDM (Windows)
Sample rate 44.1 KHz
48 KHz
88.2 KHz
96 KHz
Bit depth 16 bit
24 bit
32 bit
5.4.2. "Settings" Tab in "Dante Virtual Soundcard".
The "Settings" tab is the first screen you see when you open the "Dante Virtual Soundcard"
Control Panel. NOTE: Settings cannot be changed while the "Dante Virtual Soundcard" is
running. Settings cannot be changed when device lock is active.
To change settings:
1. Completely quit out of any audio applications that are using the "Dante Virtual
Soundcard".
2. Ensure device lock is inactive.
3. Stop "Dante Virtual Soundcard".
4. Change your "Dante Virtual Soundcard" settings.
5. Restart "Dante Virtual Soundcard".
6. Restart your audio application/s.

AEQ BC2000D Series Specifications

General

Brand	AEQ
Model	BC2000D Series
Category	Network Hardware
Language	English