AEQ Audio Over IP
Routing System
33
To display this dialog at any other time, click the button in the main toolbar.
Use Shared Dante Interface.
With this option selected, the selected primary network interface will
be automatically used by other Audinate software applications
installed on that computer (including Dante Via, Dante Virtual
Soundcard and Dante Firmware Update Manager) when they are
started. This helps to ensure that all Audinate applications are
connected to the same Dante network.
Only wired Ethernet network interfaces are supported in this mode.
NOTE: Selecting "Use shared Dante interface" when another Dante application is already
running means that you can only use the network interface that is in use by the other running
Dante application (the interface has already been nominated as the 'shared Dante interface').
With "Use shared Dante interface" deselected, "Dante Controller" is able to connect to any
available Ethernet or Wi-Fi network interface, and the selection is fully independent of any other
Audinate software applications.
Wi-Fi Network Connections.
To connect to a Dante network via Wi-Fi, a Wi-Fi access point must be present and enabled on
the Dante network - for example, a Wi-Fi router physically connected to a network switch or
Dante device in the Dante network.
NOTE: Dante audio transmission over Wi-Fi is not supported.
To connect to a Dante network using Wi-Fi:
1. Ensure your Wi-Fi interface is successfully connected to a Wi-Fi network.
2. Ensure "Use shared Dante interface" is deselected.
3. Select your Wi-Fi network interface in the "Configure Dante Interfaces in Unmanaged
mode" dialog.
Operational 1Gbps Ethernet interface
Operational 100Mbps Ethernet interface
Disabled / disconnected Ethernet interface, or no interface selected
Operational Wi-Fi interface
Wi-Fi interface selected with no Wi-Fi network connection
To Next Page
Loading...
Need help?
General
