AERMEC VMF-E5 - Page 8

8
GB
6795773_01
Technical room
Quantity
Element Notes
x 1
ANLI70HX
Heat pump to provide the required output to heat and condition the system (heat pump with compressor
and inverter hydraulic pump).
x 1
MODU - 485A
RS-485 interface for supervision systems with modbus protocol (accessory necessary to implement
communication between the chiller/heat pump and VMF system).
x 1
VMF - ACS3KTM Electric control board to control loads involved in management and production of domestic hot water.
x 2
VMF-CRP
To implement the system used in this example, two accessory VMF - CRP expansion boards are
necessary; one is used to manage the recovery unit, the VOC probe and the boiler; the other manages
the 4 pumps serving the zones.
x 1
VMF-VOC Air quality detection probe; an air recovery unit can be managed based on that detected by this probe.
x 1
UR
Air recovery unit; thanks to the VMF - VOC probe, this unit is used to guarantee air exchange inside the
VMF system.
x 1
System Storage Tank
All of these parts are NOT supplied by Aermec, but are considered as necessary parts to implement the
VMF system; the general connections to insert them in the VMF system will be indicated for them.
x 1
Supplementary
electric resistance for
DHW
x 1
DHW storage tank
x 1
3-way diverter
valve
x 1
Temperature probe
for DHW storage tank
x 4
Pumps