AERMEC VMF-E5 - VMF System - Material Required; Zone A Material List; Zone B Material List; Zone C Material List

7
GB
6795773_01
VMF System - Material required
NOTE: the proposed example requires different system components and relative accessories; this section provides
a detailed list of the material required for each zone.
ATTENTION: some elements of the system are NOT available as AERMEC accessories; the installer is in
charge of choosing, dimensioning and adapting material to the VMF system; however, in this example, these
components will be listed generically WITHOUT REFERRING TO ANY SPECIFIC SIZE.
List of material required to implement system:
Zone
A
Quantity
Element Notes
1
FCXI P
The selected ductable inverter unit will allow both rooms of the zone to be served without inserting further
units; naturally proper ducts must be implemented to do this.
x 1
VMF-E18 This thermostat is necessary to manage an inverter unit in a VMF system.
x 1
VMF - E4 This wall-mounted panel allows to pilot the master of the zone to which it is connected.
Zone
B
Quantity
Element Notes
x 1
Omnia HL This zone has only one room which will be served by one sole fan coil.
x 1
VMF-E1 This thermostat is necessary to manage a MASTER unit in a VMF system.
x 1
VMF - E4 This wall-mounted panel allows to pilot the master of the zone to which it is connected.
Zone
C
Quantity
Element Notes
x 1
Omnia HL This zone has only one room which will be served by one sole fan coil.
x 1
VMF-E1 This thermostat is necessary to manage a MASTER unit in a VMF system.
x 1
VMF-E2H This interface allows to pilot the master fan coil selected for the zone.
Zone
D
Quantity
Element Notes
x 2
Omnia HL This zone has only one room, which will be served by two fan coils (one MASTER and one SLAVE).
x 1
VMF-E1 This thermostat is necessary to manage a MASTER unit in a VMF system.
x 1
VMF - E0 This thermostat is necessary to manage a SLAVE unit in a VMF system.
x 1
VMF-E2H This interface allows to pilot the master fan coil selected for the zone.
Zone
E
Quantity
Element Notes
x 3
Omnia HL This zone has only one room, which will be served by three fan coils (one MASTER and two SLAVES).
x 1
VMF-E1 This thermostat is necessary to manage a MASTER unit in a VMF system.
x 2
VMF - E0 This thermostat is necessary to manage a SLAVE unit in a VMF system.
x 1
VMF-E2H This interface allows to pilot the master fan coil selected for the zone.
x 1
VMF-E5
This interface allows to pilot the ENTIRE VMF system; this component is not part of any zone as it pilots all
of them.